Masked & Blended Leaves

Posted: October 24, 2024 | Author: | Filed under: Echidna Studios, grafix, Leaves digital stamps and cut files, Spellbinders | Tags: , , , , | 5 Comments

It’s been a couple of weeks since I posted, sorry about the blog neglect. In my last post (which also featured leaves) I mentioned I had just started to see some reds and oranges along with the earlier yellow leaves. This week the colours have been stunning! So many deep reds contrasting with the remaining greens and still more yellows and oranges. Even crawling in traffic has had its upside as I gaze at the autumn leaves.

About a month ago I posted a video showing how I created a watercolour painting of leaves using masking (more leaves). Today’s card featured the same process using a maple leaf design from the Echidna Studios Leaves digital stamp set. Instead of painting the final dark layer over the masks, as shown in the video, this time I blended chipped sapphire ink using a blending brush. I think the navy edge around the leaves shows them off beautifully but because I didn’t blended too heavily you can still see the watercolour underneath. I finished this card off with a layered sentiment from the Spellbinders ‘serenade sentiments etched dies set‘

This post includes affiliate links from Foiled Fox. If you buy through these links I receive a small commission at no extra cost to you.

Masked Autumn Leaves – Video

Posted: September 23, 2024 | Author: | Filed under: Echidna Studios, grafix, Leaves digital stamps and cut files, Tutorial | Tags: , , , | 4 Comments

I recently completed an autumn painting using Grafix extra tack frisket film to mask autumn leaves. I began by painting the whole panel in yellows, oranges, reds, browns and greens. I used watercolour paints and did some mixing on my palette and also on the hot pressed watercolour paper.

Once I had a multicoloured panel I added maple leaf masks cut on my Cricut from Grafix extra tack frisket film. I used the maple leaf image from the new Echidna Studios Leaves digital stamp and cut files set. The set includes six different leaves: Hickory, Maple, Honey Locust, Linden, Sumac, and Oak. I cut maple leaves in a variety of sizes. Watch the video below to see the whole process.

I liked using this method rather than painting one leave at a time because it was quicker and resulted in more random colour patterns on the leaves.

I left my panel as an 8.75″x11.25″ painting but you could also cut a panel up into several pieces to make autumn or thanksgiving cards.